Easy-to-Install Outdoor-Rated Low-Level Tank Alarm from Alderon

Need a simple way to monitor your tank level? The VersAlarm Low-Level Tank Alarm is a great way to get alerted if your water tank falls below a certain level (determined by the position of the included float switch).

The VersAlarm™ 4X 1-Zone Tank Alarm with included auxiliary contacts is outdoor rated and powered by 120VAC, with conduit connections (required). When powered, the green LEDs (bottom/middle) will illuminate (solid) to indicate the alarm is powered and the included two-level press-and-hold feature can disable LEDs.

Install a 9VDC lithium battery (not included) for battery backup during power outages. Alarm LEDs and buzzer give two quick pulses every 10-seconds to indicate a low battery.

This alarm panel can be used for a wide variety of applications, including but not limited to: septic tanks, sump pits, holding tanks, pump chambers, and water tanks. The alarm panel is equipped with audible and visual alarm indication, activated by the normally closed float switch wired to the quick connect terminals.

A variety of sensors can be used such as a float switch, pressure switch, or any "dry" type sensor that "closes" during an alarm condition (normally open or normally closed). Use the auxiliary contacts to connect to building automation systems (BAS) and phone dialers. An optional pump terminal block can be added to connect incoming pump power, pump connections, and pump switch in the same enclosure with a separate conduit entrance.

How it Works

An alarm condition occurs when the float switch (signaling device) contact is activated, during which the red alarm LEDs will illuminate (flashing) with the left green LED illuminated (solid) for zone alarm indication, buzzer will annunciate with a pulse tone, and auxiliary contacts will activate. The alarm condition will stay on until the float switch is deactivated. Press and hold (1-second +) the test/silence capacitive touch button to silence the buzzer during an alarm condition, the alarm LEDs remain illuminated, flashing. The silence condition will reset when the float switch deactivates and the alarm will auto reset for the next alarm cycle. Test alarm monthly to ensure system integrity.

For an indoor-rated, less expensive version, see our Indoor Low-Level Tank Alarm

For an effective tank monitoring system, check out our PTLevel Wireless Tank Gauge

RELATED PRODUCTS:

Cable Weight for Float Switch Tethering